How to use and maintain ultrasonic cleaning machine

With the rapid growth of modern vehicles, locomotives, aircraft and other means of transport, the maintenance services put forward higher requirements. The traditional method of cleaning parts can not meet the requirements of the modern engine, gearbox and other major parts of the re assembly process requirements, parts cleaning in modern maintenance enterprises occupy an increasingly important position.

So after the procurement of ultrasonic cleaning machine, how to use and maintenance?

Safe operation flow of ultrasonic cleaning machine:

1, check

Open the packing box, check the appearance of the equipment is damaged, control the electrical components inside the box is loose, if loose, you need to fix. In case of any damage, please contact us immediately.

2, wiring

The power line, the aviation plug and the heater power supply according to the wiring diagram the correct access control box, and grounding; if do not understand the problem, please contact customer service department, we will call the whole instruction; if you have any special needs, will be rushed to the site for installation commissioning training.

3, preheating

Closed air, the temperature control meter set to 70 degrees (also set the temperature according to the actual situation), start the total power supply and heating switch, start heating.

4, into the cleaning agent

When the temperature is heated to the set temperature, the cleaning agent is uniformly melted and then put into the cleaning tank, and the ultrasonic power supply is turned on, so as to reach the working state.

5, pretreatment

The surface of the workpiece, such as heavy oil, coke and other attachments for pretreatment, preparation for the road cleaning.

6, ultrasonic cleaning

The workpiece into the cleaning tank, according to the different parts of the cleaning time, cleaning.

Note: the workpiece is put into the ultrasonic cleaning tank, cleaning, due to differences in temperature and temperature fluctuations and other parts in the water, there may be relatively harsh Whistler, this phenomenon is normal, a few minutes to calm down level is good, please do not panic.

7, rinse drying

When the time is set, remove the cleaning parts, rinse with water and remove the adhesive attached to it.